ATTO EPCI-ESTR-000 Technical Information download pdf (Page 13)

ATTO ExpressStripe Installation and Operation Manual

Possible error messages

[VolumeName]: Partition was not created.

Each partition is tagged with this message before it

has been manipulated. Reboot and try creating a

volume again.

[Partition map is full.

You can create no more than 30 partitions per disk.

The system has not been changed.

[VolumeName] was not formatted.

Each volume is tagged with this message after the

partition map has been saved. The volume cannot be

mounted but takes up space. You may mount the

volume if you use

newfs

to lay down the proper format

on the corresponding volume device.

[VolumeName] – could not format.

The program can’t lay down the format on this volume.

Other volumes may be formatted.

[VolumeName] created.

This is the success message; everything worked as

expected.

[VolumeName]: BSD name does not exist.

IOKit

does not make the volume devices after the

new partition map has been saved, there is nothing to

format. Reboot and either

newfs

the proper volume

device or initialize the entire drive.

FileNotFoundException

IOException.

Indicates that the partition map could not be saved

which could occur after a partition map has been

saved. No changes are made.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

No comments

ATTO EPCI-ESTR-000 Technical Information Page 13